The short tube filler in hygienic design is used to fill beer or carbonated soft drinks in glass or PET bottles.
The filler is blocked with crown cork capper, screw capper, and/or ring pull capper according to the project requirements and is driven by frequency-controlled motors.
The bottles are supplied to the filler in handling parts, designed for quick changeover, and made from high wear-resistant plastic material.
Both cold fill and warm fill up to 15°C are possible. Bottles are pressurized with CO2 and filled under counter pressure.
The fill height is controlled by vent tubes or electric probes followed by a multiple-step pressure release.
All parameters can be easily adjusted on the HMI.
The filer is equipped with oxygen measurement, a fully automatic CIP and COP process, safety separation plates, and a spraying system to avoid contamination with broken glass.
All parts of the bottle filler and crowner are designed for easy cleaning and sterilization.
FILLING TECHNOLOGY
JZY: Mechanical filler with vent tubes and cam control.
DPG: Pneumatic valve control integrated into the ring bowl for evacuating, flushing, purging, pressurizing and filling. No mechanical control cams are required.
TDZY: Electronic controlled filler with fill height sensor.
DGY Bottled Water Production Line
CAPACITY
Max 43.000 bph
BRIEF INTRODUCTION
The Lines are designed to fill mineral water，purified water or other non-carbonated beverages into PET bottles.
BASIC PARAMETER
Model:
GX60-20
Power supply:
AC380V, DC24V
Installed power:
280KW
Air supply pressure:
0.7MPa
Air consumption:
1.0 m3/min
Quantity of machine stations:
20(capping head)
Main applicable bottle type:
PET Bottle
Applicable bottle diameter:
55-97mm
Applicable bottle height:
150-340mm
Material conductivity:
≥25μs
Filling precision:
±3-5 ml
Machine size:
L2904mm×W2899mm×H2924mm
Machine weight:
about12t
Environment condition:
Humidity <95% (no condensation), Temperature -10-50℃, Horizontal solid concrete floor (concrete thickness >10cm)
